RX01 felt pad (Tim)

[Tony Duell]

> 
> Much easier on an RX01.  I don't have to remove the drive.  Remove 
> 3 screws from top board, and flip back.  Remove 8 screws on lower 
> board and remove a few cables (remembering where they go) and lift
> lower board and tilt towards back of unit.  There thru two pretty
> good sized access holes are the heads and all.  I simply put a small

The RX02 is like that too -- in fact the drives, chassis, PSU, front 
panel, etc are generally the same between the 01 and 02 (there is some 
issue of a resistor on the head connector, but...)

But since the drive is so easy to remove (take off the fan plenum at the 
back, unplug the wiring, undo 6 screws, and it comes out downwards), I'd 
take it out. Access to the assembly is then a lot easier.

-tony