Panel question

[Gooijen, Henk]

>  --- On Tue 11/15, Wolfe, Julian < ISC277 at CLCILLINOIS.EDU > wrote:
> From: Wolfe, Julian [mailto: ISC277 at CLCILLINOIS.EDU]
> To: info-pdp11 at village.org, cctalk at classiccmp.org
> Date: Tue, 15 Nov 2005 17:28:40 -0600
> Subject: Panel question
> 
> I'm trying to mount the front panel on my 11/34, but I've run 
> into aproblem: I have no mounting brackets. What do the 
> brackets look like formmounting to a BA11-K, and does anyone 
> here have any extras?Secondly, was there a H964x style beige 
> panel with black vents that would goon the non-covered 
> portion of the 11/34a's BA11-K?  I seem to rememberseeing 
> that sort of thing on some 11/44s and 11/24s.Again, any 
> advice would be appreciated.
> 
> ------------
> 
> I thought I had an extra, and was going to look at it.  Seems 
> like I must have sent it off to someone.  It's not like the 
> older clip on panel types.  It is screwed to a bracket.  If 
> no one else comes forward I'll remove the one from my 11/34 and look.
> 
> As to the other panel, mine is simply a 1/2 DEC black panel 
> screwed in from the front above the programmer panel.
>   Tim R

As far as I can remember (at work now) they have the following shape,
the bracket is drawn in front of the box. The "s" is a hole in the
bracket. The flange (at both sides) at the front side of the box has
also a (bigger) hole. You put in a screw (s) from the rear side of
the flange, through the bracket and tighten the screw on the front
panel. See the figure. F=front panel, B=bracket, BA=box.
Making such a bracket from a strip of aluminium should not be too
difficult.

   F        B     BA
  ___      __   ____
  |  |     | |  |
  |  |     | |  |
  |  |     | |  |   this part is
  |  |    /  /  |   the BA11K box
  |  |   |  |   |
 /   | s |  |   | <---screw from here
|    |   |  |   |
|    |    \  \  |
|    |     | |  |
|    |     | |  |
\____|     |_|  |_____


- Henk, PA8PDP.

This message and attachment(s) are intended solely for the use of the addressee and may contain information that is privileged, confidential or otherwise exempt from disclosure under applicable law.  
If you are not the intended recipient or agent thereof responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this communication is strictly prohibited.  
If you have received this communication in error, please notify the sender immediately by telephone and with a "reply" message.  
Thank you for your cooperation.