LA210 Schematics

[Tony Duell]

> >Easiest starting point is to check operating voltages.  If during 
> >printing they drop or go flakey it's the PS.  The fact that it 
> >prints at all says most of the logic is solid and working.
> >
> >Allison
> >
> >
> >  
> >
> One of the reasons I want some kind of schematic.
> 
> So I can know what voltage levels should be where, and if I find

There pretty much has to be a +5V line for the TTL, microprocessor, etc. 
You can find that from data sheets on some of the ICs. I'd start by 
checking the voltage between that and logic ground (found on the gnd pin 
of similar ICs). 

-tony