help - 11/34 console problem -- CNTRL key behaviour

[Gooijen, Henk]

  Ok. I might check ...
But is it possible that 2 years of non-use, and never any mechanical
change/adjustment can cause this misalignment?
Further, I never removed the PCB from the metal front, always removed
the whole panel from the chassis (1 screw at each side).
And the buttons all worked a week ago, I could enter any number and
every number button stroke showed in the display ... so, removing the
PCB now is perhaps not the first thing I would do right now.
But I will keep it in mind!

  tnx,

- Henk, PA8PDP.


> -----Original Message-----
> From: cctalk-bounces at classiccmp.org 
> [mailto:cctalk-bounces at classiccmp.org] On Behalf Of John Allain
> Sent: woensdag 9 november 2005 17:00
> To: General Discussion: On-Topic and Off-Topic Posts
> Subject: Re: help - 11/34 console problem -- CNTRL key behaviour
> 
> > Any input is welcome!
> 
> Don't ignore the possibility that the panel is mechanically 
> misaligned.
> That is, that the keypad isn't causing the keyswitches to be 
> depressed properly.  It just takes ~8 phillips head screws to 
> find out IIRC.  I had two of these panels, one with this 
> problem that was realignable.
> 
> John A.

This message and attachment(s) are intended solely for the use of the addressee and may contain information that is privileged, confidential or otherwise exempt from disclosure under applicable law.  
If you are not the intended recipient or agent thereof responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this communication is strictly prohibited.  
If you have received this communication in error, please notify the sender immediately by telephone and with a "reply" message.  
Thank you for your cooperation.