Update and Pictures: It's been a hell of a day! HP 9845/2x

[Tony Duell]

>    I checked the HP 9845B and it's absolutely dead. The fan doesn't even
> run. However the fault should be easy enough to locate. It's odd though,

Be warned that thr 9845 PSU is _very_ complicated, even worse than the 
PDP11/44 PSU (!).

Anyway, the input circuit isn't too bad. There's a mains-frequency 
transformer (the laminated-core one on the metal bracket) that has 2 
primary windings. They're in series for 230V, in paralell for 115V. The 
output of this transformer provides the startup supply. There's also the 
conventional bridge/doubler circuit with the 2 massive capacitors in the 
middle of the PSU mainboard to supply 350V DC to the choppers

Anyway, the fans are connected in parallel with the startup transformer 
primaries. So on 115V they're essentially connected across the mains. 
There is a fuse at the back (10A IIRC for 115V) that I'd check first, 
otherwise look at the wiring on the back panel, the barrier strip on the 
side of the PSU casing (be warned that the screws that hold the cover 
over that go into loose nuts inside the PSU casing, so pull the PSU 
module first), etc. This is one of the not-too-complicated parts of the 
machine.

-tony