Simulated disk drive for RT-11?

[Randy McLaughlin]

From: "Ethan Dicks" <ethan.dicks at gmail.com>
Sent: Monday, June 06, 2005 2:22 PM


> On 6/6/05, Allison <ajp166 at bellatlantic.net> wrote:
>> >You could make one like DEC used to: Take an 8-slot backplane, and
>> >fill in four of the slots with epoxy. You now have a 4 slot backplane.
>>
>> Yes but can you fit that in a 4.25x13x12 box with power supply?  That's
>> a BA11-VA, aka shoebox.
>
> With a large enough hydraulic press...
>
> :-)
>
> -ethan

I didn't know it was OK to use a hydraulic press for PC board installation, 
I was always told that if it didn't fit then you needed a bigger hammer.  4 
pound hammers are less likely cause less damage than hydraulic presses.


Randy
www.s100-manuals.com