BA123/RQDX3 floppy question

[Brad Parker]

Allison wrote:
>
>That distribution board has a connector labeled RX50.  The RQDX3 has a 50 pin 
>cable that goes to that disti board and from there you should have the usual 
>rats nest of 34pin (floppy), and 40/26pin (hard disks) from the distibrution
>board to drives.

thanks!  (I finally found a BA-123 manual also)

I have two other questions:

- can I pull out the distribution board and pop it into another QBUS, say
  on an 11/23+?

- do I need the front panel 'thing' (the led board) or can I leave it 
  disconnected?

-brad