RLV12 located with cable

[David Betz]

I don't need an RL01/RL02 cable anymore but I could use the cables/ 
panels needed to connect an RQDX3 to an MFM hard drive.

Alternatively, a BA23 would be nice. Have one of those to sell?

Thanks!
David

On Dec 1, 2005, at 2:07 PM, Joe Heck wrote:

> David Betz wrote:
>
>> I have a wire that is broken on the Berg connector that plugs into  
>> my  DLV12 controller for my RL01 drive. How do I remove one of the  
>> pins  from the Berg connector so that I can reattach the broken  
>> wire? Is it  possible to repair these connectors or do I have to  
>> replace it?
>>
>>
> Sure enough, I finally found my RLV12 with the ribbon cable and  
> adapter.  I noticed your email about getting it running already, so  
> does that mean you don't need a cable any more?
>
> The RLV12 was at a customer site that I had already looked at, but  
> apparently not thoroughly enough.
>
> Joe Heck
>