RLV12 located with cable

[Joe Heck]

David Betz wrote:

> I have a wire that is broken on the Berg connector that plugs into my  
> DLV12 controller for my RL01 drive. How do I remove one of the pins  
> from the Berg connector so that I can reattach the broken wire? Is it  
> possible to repair these connectors or do I have to replace it?
>
>
Sure enough, I finally found my RLV12 with the ribbon cable and 
adapter.  I noticed your email about getting it running already, so does 
that mean you don't need a cable any more?

The RLV12 was at a customer site that I had already looked at, but 
apparently not thoroughly enough.

Joe Heck