


Version 2.00        CAROUSEL TOOLKITS (tm)          MS-DOS 2.x


                       USE-A-TOOLKIT (tm)


Files  on  these diskettes are copyrighted (c), 1984, by Carousel
MicroTools, Inc., and may be used only in accordance with a  duly
executed software license from Carousel MicroTools, Inc. 

The following files are on these diskettes: 

   README       -- Disk 1 -- this file
   CONTENTS     -- Disk 5 -- complete list of files provided
   GROUPS       -- Disk 5 -- names of Tools served by each Toolbox
                               and where to find them
   CONFIG.SYS   -- Disk 1 -- suggested configuration file
   AUTOEXEC.BAT -- Disk 1 -- suggested startup batch file
   WORKDSK*.BAT -- Disk 5 -- batch files to build working floppies
   *.COM        -- all disks -- loader program, one per Tool
   *.EXE        -- all disks -- eleven Toolboxes
   *.BAT        -- Disk 5 -- batch files for rc, fcld, ld Tools


                      SPECIAL INSTRUCTIONS

DO  NOT  write on these diskettes.  Do not erase or rename any of
the files on them.  They are your MASTER DISKS.  Keep them  safe!
Make backup copies of them right away. 

First   carefully  read  the  installation  instructions  in  the
manual.   The  special  instructions  for  this  product  are  as
follows: 

1) Disk   1   contains  copies  of  the  minimal  CONFIG.SYS  and
   AUTOEXEC.BAT files suggested by the manual.  You can use  them
   directly on your boot disks or combine them with your existing
   configuration files. 

2) Take  note  of  the Tools served by each of the Toolbox files.
   They are listed in the file GROUPS on Disk 5.  If you  do  not
   keep all of the Tools and Toolboxes on your system at the same
   time,  you  will  need  to be sure that each Tool can find its
   Toolbox when you use it. 

3) If you use the Tools from floppy disks, you will probably find
   that they will not all fit on the system  at  the  same  time.
   You will need to build working diskettes containing convenient
   groups  of  the  Tools.   The four batch files WORKDSK*.BAT on
   Disk 5 are provided to build four such working Tool  diskettes
   from   empty   (but  formatted)  double-sided  floppies.   The
   resulting floppies will each contain around 270K bytes of Tool
   programs, leaving around 90K bytes for other files.   You  may
   need  to build different kinds of working Tool diskettes using
   the WORKDSK*.BAT files as a model. 








