TQK70 configuration

[SHAUN RIPLEY]

--- Philippe Vachon <phirkel at sympatico.ca> wrote:

> Hello (again!).
> 
> I'm very pleased with my VAX 4000/300 thus far, but
> I'm about to get a 
> KZQSA card from someone, and I need to move my TQK70
> controller over on 
> the Q-bus so that the KZQSA card can fit into the
Make sure there is no gap between your Q-bus cards.

vax, 3900

> machine. However, 
> when I did a test run of this, the card was
> responding (show dev showed 
> the card), but it wouldn't find the TK70 tape drive
> attached to the 
> TQK70. Is there a jumper I have to set? Or did I
> screw up in some other 
> way?
> 
> Thanks.
> 
> Phil.
> 
> 



		
__________________________________
Do you Yahoo!?
Yahoo! Mail - 50x more storage than other providers!
http://promotions.yahoo.com/new_mail