TQK70 configuration

[Philippe Vachon]

Hello (again!).

I'm very pleased with my VAX 4000/300 thus far, but I'm about to get a 
KZQSA card from someone, and I need to move my TQK70 controller over on 
the Q-bus so that the KZQSA card can fit into the machine. However, 
when I did a test run of this, the card was responding (show dev showed 
the card), but it wouldn't find the TK70 tape drive attached to the 
TQK70. Is there a jumper I have to set? Or did I screw up in some other 
way?

Thanks.

Phil.