Cables for RX50 in BA23

[Tony Duell]

> Be careful!  The first (only if you are using only one)
> hard disk drive uses DS3.  The RX50 rarely needs any
> settings changed - I would not know how if asked since
> I have never used more than a single (dual) RX50.

There is a single, unmarked, jumper on the seek/interface PCB in the RX50 
-- the one mounted verticalled at the back of the drive that the 
interface cables plug into. It's normally unjumpered. Jumering it will 
change the drive selects from 0,1 to 2,3. I don't know if that's what 
needs to be done, but it seems likely.

-tony