[OT]Homebrew PCB fabrication

[der Mouse]

> Just in case it is obvious, but did you check the prices for 2 layer
> boards ?  I think the prices are as low as never before, so I
> wouldn't even start to do it on my own.

Neither would I - if I could find enough documentation on the file
formats they accept for me to build the necessary data files for hem.

Everybody I've looked into handwaves the issue, naming a couple of
formats ("gerber" comes to mind) without any references, apparently
assuming everyone will be using some kind of pre-rolled software to
generate said files.  Feh.

/~\ The ASCII				der Mouse
\ / Ribbon Campaign
 X  Against HTML	       mouse at rodents.montreal.qc.ca
/ \ Email!	     7D C8 61 52 5D E7 2D 39  4E F1 31 3E E8 B3 27 4B