Veroboard trace cutting tool?

[Pete Turnbull]

On Dec 5 2004, 13:31, Bert Thomas wrote:
> > However, if I want it to look neater (I meant to mention this in my
> > previous message) -- though goodness knows who would care -- I have
> > been known to use a scalpel or craft knife to cut the copper either
> > side of a hole and then lift off the small redundant piece.  I've
also
> > done that between holes, when I wanted to use two adjacent holes
but
> > isolated from each other.
>
> Aaarggghhh, <undo><undo><undo><undo><undo>... ;-)

Why "undo"?  Great minds obviously think alike, and two posts just
reinforce the value of the advice :-)

-- 
Pete						Peter Turnbull
						Network Manager
						University of York