Veroboard trace cutting tool?

[Ethan Dicks]

Does anyone know where I can locate a genuine tool for severing the
traces on veroboard?  I know I can make do with a drill bit, but that
puts a tapered hole in the resin board underneath.

One thing that's cheaper in NZ is, strangely enough, veroboard.  The
few pieces I found in the States were priced much higher than
protoboards used to be at Rat Shack (when you could find them).  I
occasionally run into a project from a UK experimenter, and have
wanted to do their designs without doing 100% point-to-point.  I'll
probably bring home a couple of panels so I have a chance to do that
(for my own stuff, I'll probably always do point-to-point).

-ethan