.; THIS FILE IS USED TO RUN VMR ON OTHER THAN THE SYSTEM DISK
	; Cancel local assignments
	ASN =
	; These are the current system and library device assignments.
	; Do not run VMR on these disks.
	DEV SY:
	DEV LB:
.WHICH: .ASKS DRV What drive do you want to run VMR on (DBn:)?
	.ENABLE SUBSTITUTION
	.IFNINS VMR .SETT REMVMR
	.IFNINS BOO .SETT REMBOO
	ASN 'DRV'=SY0:
	ASN 'DRV'=LB0:
	.IFNINS VMR INS [3,54]VMR
	; Local assignments have been made for SY: and LB: to 'DRV'
	.ASK OK Is this correct?
	.IFF OK .GOTO WHICH
	.SETS UIC <UIC>
	SET /UIC=[1,54]
	.SETF NOVMR
	.SETF NOTSK
	.SETF NOSTB
	.TESTFILE SYSVMR.CMD
	.IF <FILERR> NE 1 .SETT NOVMR
	.TESTFILE RSX11M.TSK
	.IF <FILERR> NE 1 .SETT NOTSK
	.TESTFILE RSX11M.STB
	.IF <FILERR> NE 1 .SETT NOSTB
	.IFF NOVMR .IFF NOTSK .IFF NOSTB .GOTO GOTEM
	.IFT NOVMR ; SYSVMR.CMD is missing.
	.IFT NOTSK ; RSX11M.TSK is missing.
	.IFT NOSTB ; RSX11M.STB is missing.
	; Cancelling local assignments.
	ASN =
	.IFDF REMVMR REM VMR
	SET /UIC='UIC'
	/
.GOTEM:	PIP RSX11M.SYS/NV/CO/BL:1026.=RSX11M.TSK
	VMR @SYSVMR.CMD
	; Cancelling local assignments.
	ASN =
	.IFDF REMVMR REM VMR
	SET /UIC='UIC'
	; 
	; To save the new system, REBOOT from a known good pack and hit
	; CNTL/Z when asked for time and date. Then enter:
	;
	;	CON ONL DBn:	-- where DBn: is the pack you VMR'ed
	;	MOU DBn:/OVR
	;	BOO DBn:[1,54]RSX11M
	;
	; The system will boot from the newly VMR'ed pack but with no STARTUP.
	; Then enter the TIM command, and give time and date.
	; Now type "TIM" again; if it echos properly, enter the
	; following SAVE:
	;
	;	SAV /MOU="/ACP=SYSDSK/LRU=20"
	;
	; If the VMR was proper, the system will now reboot "normally"
	; from the newly VMR'ed pack. When asked for time and date,
	; hit CNTL/Z (unless you want to do further testing before the
	; final save, in which case, continue; when testing is completed,
	; halt the system, reboot from another pack, and repeat the above
	; BOO command). Now enter the SAVE WRITE-BACK:
	;
	;	SAV /WB/MOU="/ACP=SYSDSK/LRU=20"
	;