; BUILD MAPPPED PIP
;
[1,54]PIP/-FP/CP/MM,MP:[1,34]PIP/-SP=[1,20]PIPBLD/MP
STACK=64
TASK=...PIP
UNITS=6
ASG=TI:1:2,SY:5
;
; NOTE: IF YOU REBUILD PIP WITH ANSI MAGTAPE SUPPORT,
;	YOU WILL HAVE TO ALTER THE PARTITION STATEMENT
;	IN THIS BUILD FILE, OR INSTALL PIP WITH THE
;	/INC SWITCH, AS THE ANSI MAGTAPE ROUTINES CAUSE
;	PIP TO GROW SO THAT THERE IS NO ROOM FOR BUFFERS.
;
PAR=GEN
EXTTSK=928		; make it 40000 big
PRI=50
TSKV=SSTTAB:7
;
; PATCH THE LUN USED BY GERRM
GBLPAT=ERROR:.EOLUN:5
;
; PUT LINE PRINTER WIDTH (OCTAL) AFTER LPTLEN: IN THE FOLLOWING COMMAND
; 120 OCTAL FOR 80 COLUMN PRINTER, 204 OCTAL FOR 132 COLUMN PRINTER
GBLPAT=PIP:LPTLEN:204
;
; WHEN COPYING FILES TO THE LINE PRINTER, PIP WILL ISSUE A FORM
; FEED BEFORE COPYING THE FILE.  IF THIS IS UNDESIRABLE, REMOVE
; THE COMMENT FROM THE NEXT LINE.
;
;GBLPAT=PIPCPY:.LPCHK+10:000410
;
; WHEN BUILDING FOR RSX11D WITHOUT THE DYNAMIC MEMORY FACILITY
; AN EXTSCT MUST BE DONE FOR $$DYB1.  THE FOLLOWING GUIDELINES ARE OFFERED
;	MINIMUM: 2040+1000
;	MINIMUM FOR AUTOMATIC DOUBLE BUFFERING = 4*1020+1000
;	THE MORE YOU ALLOW, THE BETTER PERFORMANCE FROM BLOCK MODE COPY.
/