!
!	SPY.CMD	- LINK COMMAND FILE FOR SPY.TSK
!
TYPE SPYBLD.DOC
!
LINK/OP/TASK:SPY.TSK/PR/MU/MAP:(SPY.MAP)/OV:SPY.ODL
ACTFIL=0
LIBR=IASCOM:RO
LIBR=SYSRES:RO
TASK=$$$SPY
UIC=[1,1]
MAXBUF=0
UNITS=1
ASG=TI:1
;
;	GLOBAL DEFINITIONS FOR DEFAULT PARAMETER SETTINGS
;
;	MAXTT	- MAXIMUM # OF TERMINALS ON SYSTEM.  THIS IS FOR 'TT'
;		  TYPE DEVICES ONLY, AND NOT INCLUDING THE CONSOLE (TT0).
;		  THIS SHOULD BE THE SAME AS THE HIGHEST UNIT NUMBER FOR
;		  A 'TT' DEVICE. E.G. IF YOU HAVE A DZ WITH 16 LINES, THEN
;		  MAXTT:20 IS THE PROPER SETTING.
;		  SPY WILL SUPPORT 64. TERMINALS, DOES IAS ?
GBLDEF=MAXTT:40		; DEFAULT TO 32. TERMINALS
;
;	MAXBA	- MAXIMUM # OF BATCH STREAMS ON SYSTEM. 'BA' DEVICES.
;		  THE ABOVE ALSO APPLIES FOR MAXBA.
;		  IF YOU RUN WITH AT MOST 4 BATCH STREAMS THEN
;		  MAXBA:4 IS THE CORRECT SETTING.
GBLDEF=MAXBA:10		; DEFAULT TO 8. BATCH STREAMS
;
;	**NOTE** MAXTT+MAXBA+1 MUST NOT EXCEED 'MCTTBA' IN SPYCM.COM.
;
;
;	THE FOLLOWING 6 WORDS DEFINE THE DEFAULT TERMINAL RANGE TO BE
;	DISPLAYED WHEN SPY2 STARTS UP.
;	ICNSOL SHOULD BE NON-ZERO TO BE INCLUDED IN DEFAULT DISPLAY.
GBLDEF=ICNSOL:1
;
;	NOW DEFINE FOR 'TT' BETWEEN UNITS "1-"100 (1.-64.)
;	BIT 0= TT1, BIT 2= TT2, BIT15 = TT20 ETC.
;	IF THE BIT IS ON THEN THE TERMINAL WILL BE INCLUDED IN THE DEFAULT
;	DISPLAY. DEFAULT SETTINGS SHOULD PROBABLY SPECIFY ONLY AS MANY
;	TERMINALS AS CAN BE DISPLAYED AT ONCE OR ALL TERMINALS.
GBLDEF=I1T20:177777		;TT1-20
GBLDEF=I21T40:177777		;TT21-40
GBLDEF=I41T60:177777		;TT41-60
GBLDEF=I61T10:177777		;TT61-100
;
;	NOW DEFINE FOR 'BA' BETWEEN UNITS "0-"7
GBLDEF=I0BA7:377		;BA0-7
;
;	NSECW	- DEFAULT # OF SECONDS BETWEEN DISPLAY UPDATES
GBLDEF=NSECW:4
;
;	NLTD	- DEFAULT # OF LINES TO DISPLAY (USUALLY 24.)
GBLDEF=NLTD:30
;
;	IDISP	- DEFAULT DISPLAY #
GBLDEF=IDISP:2			; DISPLAY
;
;	DEFINE THE DEAULT TERMINAL TYPE VT52=1
;	CHECK SPYIN.FTN FOR FURTHER DETAILS ON BUILDING SPY FOR VARIOUS
;	TERMINAL TYPES.
GBLDEF=ITTYPE:1
/