INSTRUCTIONS FOR DCS
 
DCS IS A PROGRAM FOR CHANGING SPEEDS ON A
DC OR DZ INTERFACE. RUN PROCEEDURE IS :
 
MCR>DCS NN		FOR YOUR OWN TTY
 
OR
MCR>DCS TTXX: NN	FOR ANOTHER TTY
 
	SPEED CHART
NN	BAUD RATE (** = DZ LINES ONLY)
--	---- ----
 
0	110
1	150 **
2	300
3	600 **
4	1200
5	1800
6	2400 **
7	3600 **
10	4800 **
11	7200 **
12	9600 **
 
 
 
DIRECTIONS FOR SPD
 
SPD IS A PROGRAM TO INFORM THE SYSTEM OF THE HARDWARE
CHARACTERISTICS OF YOUR TERMINAL. IT IS PRIMARILY DESIGNED
TO DIFFERENTIATE BETWEEN SCOPE AND HARD-COPY TERMINALS, WITH
THE INHERENT DIFFERENCES BETWEEN THEM (FORM FEED, RUB OUT MODE ETC.)
 
RUN PROCEEDURE IS:
 
MCR>SPD TTNN: 3		;TO SET TTNN:'S CHARACTERISTICS TO 3
 
OR
MCR>SPD 3		;TO SET YOUR TTY'S CHARACTERISTICSTO 3
 
THIS WILL RESET THE 4 DEVICE WORDS OF THE PUD IN 
QUESTION TO VALUES SPECIFIED BY THE CODE NUMBER
 
NUMBER		TYPE OF TERMINAL DESCRIBED
______	___________________________________
0		CONSOLE LA30 , MARGIN, 72 COL
1		CONSOLE LA30, NO MARGIN, 80 COL.
2		79 COL. SCOPE, ODD PARITY, IGNORE FORM-FEED
3		79 COL. SCOPE, ODD PARITY, CLEAR & HOME ON FORM-FEED
4		120 COL. LA36, ODD PARITY, IGNORE FORM-FEED,L.C.
5		120 COL. LA36, ODD PARITY, SOFT. FORM-FEED,L.C.
6		DUMB OLD ASR-33 TTY
7		ASR-33 WITH 150 CHARACTER BUFFER
8		80 COL HARD TERMINAL, NO PARITY,SOFT FORM FEED